Publicité
Les langues disponibles
Les langues disponibles
VENTING METHODS
This hood offers two venting methods:
Horizontal wall venting
Vertical roof venting
Roof cap
1. Decide where the ductwork will run between the hood and the outside.
2. A straight, short duct run will allow the hood to perform most efficiently.
3. Long duct runs, elbows and transitions will reduce the performance of
the hood. Use as few of them as possible. Larger ducting may be required
for best performance with longer duct runs.
4. Attach an adequate length of duct to the air outlet adapter.
5. The air must not be discharged into a flue that is used for exhausting
fumes from appliances burning gas or other fuels. Regulations
concerning the discharge of air have to be abided by.
6. Install a roof/wall cap. Connect metal ductwork to cap and work back
towards hood location. Use duct tape to seal the joints between ductwork
sections.
Wall cap
ELECTRICAL CONNECTION
Important : The installation must be done in accordance with all applicable
codes and standards. Refer to a qualified electrician for all electrical
connections.
Turn off electrical power at service entrance before wiring.
If the supply cord is damaged, it must be replaced by a qualified person.
Do not use a plug or an extension cord other than the ones supplied
with the hood. Grounding of this product is compulsory, do not remove
the ground prong from the plug.
OPERATIONS
A
B
FUNCTION KEYS
▪
A : Power/Delay shut down (3291079 only)
▪
B : High speed
▪
C : Middle speed
D : Low speed
▪
▪
E : Lamp on/off
OPERATION
▪
Press A to turn the hood on, there are 3 motor speeds: B-C-D.
▪
Press E button to turn on the lights.
DELAY SHUT DOWN (3291079 ONLY)
▪
When the motor is working, press A, then the delay time function begins
to work, it will continue 16 minutes before shut off. If you press B, C or D
again, it will cancel the delay time function. Pressing A will stop all
function immediately.
C
D
E
4
Publicité
