Parts Description; First Use; Operation And Maintenance - Tristar BQ-2811 Mode D'emploi

Instruction manual

PARTS DESCRIPTION

1. Handles
2. Grill
3. Heating element
4. Thermostat
2
3

OPERATION AND MAINTENANCE

• Remove all packaging of the device.
• Check if the voltage of the appliance corresponds to the main voltage
of your home. Rated voltage : 230V~,50Hz.
• Place the device on a flat stable surface and ensure a minimum of
10 cm. free space around the device. This device is not suitable for
installation in a cabinet or for inside use.
4

FIRST USE

• Attach the handles (No. 1) using the screws to the body of the barbecue.
• And then install the heating element (No. 3), being careful that the four
hooks of the heating element in the 4 recesses of the barbecue bucket
are placed.
• Place the grill (No. 2) on the barbecue.
• The device is ready for use.
1
Attention! If the heating element (No. 3) is not properly installed in the
grill tray the device will not work for security reasons.
4
USE
• Pour water into the base, make sure the water level is between Min-Max.
• Immerse the aluminum tray into the water.
• Until the aluminum tray sank under water.
• Fill the grease tray with a little water, so it is easy to clean after use.
Water should be added in good time, while ensuring that it does not
come into contact with the heating element. Plug into a grounded
outlet and turn the thermostat (No. 4) at the highest setting. The red
light comes on.
• During the first use may be some smoke and smell created. This is
normal for new heating elements and will disappear after a short time.
• Use the thermostat (No. 4) to the desired position between MIN and
MAX. To sear meat quickly select the highest setting, the MAX position.
For the quiet thread of meat and other dishes select a lower setting.
• The thermostat regulates a constant temperature. During grilling
the light comes on and off, this is normal, the temperature will be
constantly adjusted.