Vision TECHCONNECT TC-HDMI31 Mode D'emploi page 5

INSTALLATION
1. CONNECT INPUTS Plug HDMI cables into inputs. Note input and output cables are not
included with this product.
2. CONNECT OUTPUT
3. TURN MAIN SOURCE DEVICE ON Keep other source devices off at this stage.
4. TURN SWITCHER ON Plug in to mains power and turn on.
5. TURN DISPLAY DEVICE ON
RS-232 CONTROL
Baud Rate
Data Bits
Check Bits
Stop Bits
Flow Control
1. Switch command: swt+space+xx+enter
xx represents:
• 01~04 Input port
• 05 Next input e.g. 3 to 4
• 06 Previous input e.g. 3 to 2
2. Obtain current port: bc+enter
3. Standby command: pws+enter
9600 bps
8 bits
None
1 bit
None
5
TC-HDMI31_manual_en