Dreve EyeVolution MAX Mode D'emploi page 21

used. We do not accept any liability for
damage incurred by using parts which
have not been approved.
17. Independent conversions and modi-
fications are not permissible for safety
reasons.
5. Commissioning
Insert the mains cable in the device
socket (1) to establish a mains connec-
tion. The power supply unit is supplied
with the EU connector plug. The plug
adapters supplied for the UK, Japan and
the US can be replaced at the mains
device at any time.
Do this by pressing the push-button
on the inside of the power supply unit
and pulling the EU connector unit out
upwards. Insert the corresponding
plug adapter into the guide groove.
Slide it forwards until it audibly clicks
into place.
Only use the plug-in power supply pro-
vided for connecting to the mains sup-
ply; other power supply units can cause
damage to and failure of the device.
18. It is imperative that the above
operating and maintenance conditions
in these operating instructions are
observed. The general accident preven-
tion regulations must be observed when
working with the EyeVolution
Important: Read the operating instruc-
tions thoroughly before commission-
ing the device for the first time. If
there are any interpretative problems,
please contact the responsible depot or
Dreve Dentamid GmbH directly.
Scope of supply:
1x EyeVolution MAX light-curing
®
device
1x 24 V plug-in power supply unit
incl. EU connector
1x plug adapter for UK
1x plug adapter for US/JAPAN
1x operating instructions in
5 languages
MAX.
®
21