Worx WX041 Notice Originale page 7

8. DEFROSTING FROzEN PIPES
water lines often do not differ in
appearance from gas lines. Gas
lines are not to be heated under any
circumstances.
Place on the reflector nozzle. Heat the frozen
zone always from the outside to the middle.
Warm plastic pipes as well as connections
between pipe pieces especially carefully to
prevent damage.
9. SHRINK SEATING ELEcTRIcAL
cABLES
Place on the reduction nozzle. Select the
diameter of the heat-shrink tubing according
to the work piece, for example, a cable lug.
Heat the heat-shrinkable sleeve evenly.
Many adhesives (e.g. stickers) become softer
when heated allowing adhesive bonds to
be separated or superfluous adhesive to be
removed.
10. wELDING PLASTIcS
Place on the reduction nozzle and the welding
shoe. The materials to be welded and the
welding rod must be made of the same
material (e.g. PVC with PVC). The seam must
be clean and grease-free. Heat the welding
seam until it becomes tacky. Please note that
the temperature difference between the tacky
and liquid state of a plastic is very small. Then
feed in the welding rod and allow to run into
the gap so that a uniform bead is produced.
11. BENDING PLASTIc TUBE (See Fig. c)
Choose the hook nozzle and fit over heat
outlet. Turn the gun upside down and place on
its clip stand so that it is resting on a secure
bench with the nozzle pointing upwards, see
picture. To avoid buckling or kinking the tube,
fill the tube with dry sand and seal at both
ends. Heat the tube evenly by moving from
side to side and bend to required shape.
Heat gun
All manuals and user guides at all-guides.com
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
ENVIRONMENTAL
PROTECTION
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means
that this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European directive 2002/96/CE. It will then
be recycled or dismantled in order to reduce
the impact on the environment. Electric and
electronic equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.
7
EN