Setup Instructions; Dispense Cycle Setting; Program Selection; Time Setting - Invicon Precision Dispenser 100 Mode D'emploi

3.

SETUP INSTRUCTIONS

3.1 Manual/Purge Dispense Cycle Setting
1: Turn on the unit by pressing the Power button (1).
▶
2: Press the Mode button (2) until "PURGE" appears on
▶
the Display.
3:
Turn up the air pressure by rotating the Air pressure
▶
regulator knob (6) until the desired pressure is indicat-
ed on the Air pressure gauge (5).
4: After filling the barrel or using pre-packaged adhesive,
▶
attach syringe to receiver head assembly. Make certain
that the syringe locks into place.
5: Connect the plug end of the receiver head assembly to
▶
one of the air dispense outlet (7).
6: If vacuum "suck back" is needed, rotate the Vacuum
▶
regulator (8) counter clockwise until the desired vacu-
um pressure is indicated on the Vacuum gauge (9).
schlag
7: Press and hold the Footswitch to activate dispensed
▶
cycle. (The Manual/Purge Mode is now activated)
er Schä-

3.2 Program Selection

1: Press modul button (2) and select operating modus
▶
„CONTINUE" (continued process) or „INTERRUPT"
(step-by-step process)
2: Press button „SET"(3) to define operating program
▶
numbers relevant.
3: The buttons (+) and (-) allow to select the operating
▶
program desired.
4: Press „SET" (3) to finish program selection.
▶

3.3 Time Setting

1: Press and hold the Set button (3) for two seconds to
▶
enter set up screen. The last digit of the dispense time
will be highlighted.
2:
Press the Set button (3) to move the cursor to the next
▶
position.
3: Press the (+) and (-) button to set the time
▶
4: Press and hold the Set button (3) for two seconds to
▶
save the data.
5: Depress Foot switch to activate timed dispensed cycle.
▶

3.4 Cycle Counter

The cycle counter records the numbers of automatic
dispense cycle being activated. Up to 65,535 cycles can
be recorded. This number is shown at the lower right
hand corner of the LCD. To reset the counter, press and
hold the Set button (3) for two seconds to enter the set
mode. Then press and hold the Set button (3) for four
seconds to reset the counter.
invicon Product insert
invicon product insert
Precision Despenser 100 | 7
100 Precision dispenser | 7