Publicité
Les langues disponibles
Les langues disponibles
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
Electrical safety
This tool is double insulated; therefore
no earth wire is required. Always
check that the power supply
corresponds to the voltage on the rating plate.
•
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. On/off switch
2. Lock-on button
3. Dust extraction outlet
4. Sanding base
5. Paper clamp lever
6. Variable speed control knob
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting sanding sheets (fig. A)
Warning! Never use the tool without a sanding
sheet or accessory in place.
•
Soften the sanding sheet by rubbing its
non-abrasive side over the edge of a
worktop.
•
Release the sanding sheet clamp levers (5).
All manuals and user guides at all-guides.com
•
•
•
•
•
Fitting and removing the
dustbag (fig. B)
•
•
•
Connecting a vacuum cleaner
(fig. C)
•
•
Residual risks
Additional residual risks may arise when using
the tool which may not be included in the
enclosed safety warnings. These risks can arise
from misuse, prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be
avoided. These include:
Place the sheet onto the sanding base (4),
making sure that the holes in the sheet line
up with the holes in the base.
Insert the edge of the sanding sheet into the
front paper clamp as shown.
Press the front paper clamp lever (5)
downwards.
While keeping a slight tension on the sheet,
insert the rear edge of the sheet into the rear
paper clamp.
Press the rear paper clamp lever (5)
downwards.
Fit the dustbag (7) over the dust extraction
outlet (3).
Rotate the dustbag to lock it into position.
To remove the dustbag, proceed in reverse
order.
Insert the adaptor (8) into the dust extraction
outlet (3).
Connect the hose (9) of the vacuum cleaner
to the adaptor.
ENGLISH
7
Publicité
