ACDelco I-7002 Manuel Du Propriétaire page 6

B. For use with charging battery removed
from vehicle or boat
F O L L O W T H E S E S T E P S W H E N
BATTERY IS OUTSIDE OF A VEHICLE. A
SPARK NEAR THE BATTERY MAY
CAUSE BATTERY EXPLOSION. TO
REDUCE RISK OF A SPARK NEAR
BATTERY:
1. Check polarity of battery posts.
POSITIVE (POS, P, +) battery post
usually has a larger diameter post than
NEGATIVE (NEG, N, -) post (See Fig.
3A).
2. Attach at least a 24" long 6-gauge
(AWG) insulated battery cable to
NEGATIVE (NEG, N, -) battery post.
3. Connect POSITIVE (RED) charger
clamp to POSITIVE (POS, P, +) post of
battery.
4. Position youself and free end of cable
as far away from the battery as possible
- then connect NEGATIVE (BLACK)
charger clamp to free end of cable.
5. Do not face battery when making final
connection.
6. When disconnecting charger, always do
so in reverse sequence of connecting
procedure and break first connection
while as far away from the battery as
possible.
7. A Marine (boat) battery must be
removed and charged on shore. To
charge onboard requires equipment
specially designed for marine use. Use
extreme caution when removing battery
from battery compartment to avoid
arcing or sparks which may ignite
trapped gases.
DANGER
!
To reduce the risk of explosion in
marine applications:
• Ve n t i l a t e b a t t e r y c o m p a r t m e n t
BEFORE disconnecting and removing
battery.
• Use extreme caution when removing
battery from battery compartment to
avoid arcing or sparks which may ignite
trapped gases.
All manuals and user guides at all-guides.com
Battery Charger Hook-up for Negative
Ground
Charging battery removed from vehicle /
boat
NOTE: If any error code (Er0 - Er5) or LED
lights up and there is an audible 'beep', detach
clamp from battery and reconnect with close
attention to proper polarities.
MAINTENANCE
• Wipe the charger clamps clean after each
• Wipe the charger case with a clean dry cloth
• Store charger in clean, dry, and ventilated
• Store charger cord set and clamps neatly
6
use. Use emery paper to remove corrosion
from clamps.
after each use.
location.
at the back compartment of the charger.