Philips HR1619 Mode D'emploi page 8

ENGLISH
8
2 Attach the blender bar to the motor unit ('click') (Fig. 2).
3 Put the plug in the wall socket.
4 Immerse the blade guard completely in the ingredients to avoid splashing (Fig. 3).
5 Press the on/off button or the turbo speed button to switch on the appliance.
-
the speed, the shorter the processing time required.
- When you use the turbo speed button, the appliance operates at maximum speed. In this case,
Note: The higher the speed, the shorter the processing time required.
6 Move the appliance slowly up and down and in circles to blend the ingredients (Fig. 4).
7 After processing, release the on/off button or the turbo speed button to switch off the
appliance. Then wait until the blade unit has stopped rotating.
Food processor
Blade unit
The blade unit is intended for chopping ingredients such as nuts, meat, onions, hard cheese, boiled
eggs, garlic, herbs, dry bread etc.
The cutting edges of the blade unit are very sharp! Be very careful when you handle the blade
unit, especially when you remove it from the bowl, when you empty the bowl and during cleaning.
1 Place the tool holder in the bowl (Fig. 5).
2 Remove the protective cover from the blade unit.
3 Put the blade unit on the tool holder (Fig. 6).
4 Put the ingredients in the bowl.
See the table below for the recommended quantities and processing times.
Chopping quantities and processing times
Ingredients
Parsley
Onions & egg
Meat
Parmesan
Nuts
Dark chocolate
5
6 Fasten the motor unit onto the lid of the bowl ('click') (Fig. 8).
7 Put the pusher in the feeding tube.
Note: The pusher prevents spillage.
8 Press the on/off button or the turbo speed button to switch on the appliance.
-
the speed, the shorter the processing time required.
Quantity
100g
500g
300g
300g
500g
200g
Time
30sec.
7 x 1sec.(pulse)
30sec.
~ 60sec.
~ 30sec.
~ 45-60sec
Speed
12-16
1
Turbo
Turbo
Turbo
Turbo