Your Guarantee - Hoover 48024008 Manuel D'utilisation

holding the bin handle. [1]
2. Open the bin lid latch left/right and remove the water tank from bin assembly. [2]
3. Remove the foam pre-motor filters S1 and S2. [18]
4. Wash them in hand warm water [23] and allow to dry thoroughly before replacing into
the cleaner. [24]
5. Take out the EPA pre-motor filter and remove the S3 foam pre-motor filter. [19, 20]
6. Wash the EPA and foam filters [23] and allow them to dry thoroughly before replacing
to the cleaner. [24]
Cleaning the exhaust filters:
1. To remove the exhaust filters, unclip the exhaust filters cover and remove the exhaust
filters from it. [22]
2. Wash the filters in hand warm water [23] and allow them to dry thoroughly before
replacing into the cleaner. [24]
NOTE: Do not use hot water or detergents. In the unlikely event of the filters becoming damaged,
fit a Genuine Hoover replacement. Do not try and use the product without filters fitted.
Removing a Blockage From the System
If the suction of the cleaner decreases:
1. Check if the water tank and bin are full. If so refer to 'EMPTYING AND CLEANING
THE WATER TANK AND BIN CYCLONE AND BIN'.
2. If the water tank and bin are not full, then:
A. Do the filters need cleaning? If so refer to 'Cleaning the Filter'.
B. Check if there is any other blockage in the system - Use a rod or a stick to remove
any blockage from the telescopic tube or flexible hose.
ACCESSORIES AND NOZZLES
To obtain the best performance and energy efficiency #1 it is recommended that the
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as
required by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard floor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard floors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
The crevice tool, furniture nozzle and dusting brush can be stored on the tube.
Crevice Tool* – For corners and hard to reach areas. [X1]
Dusting Brush* – For bookshelves, frames, keyboards and other delicate areas. [X2]
Furniture Nozzle – For soft furnishings and fabrics. [X3]
Carpet and Floor Nozzle**- For carpet and floors. [P]
Parquet Nozzle* – For parquet floors and other delicate floors. [AA]
Pet Hair Remover Mini Turbo Nozzle*– Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. [Y]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. [Z]
IMPORTANT: Do not use mini turbo nozzles on rugs with long fringes, animal hides and
carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.
USER CHECKLIST
should you have a problem with the product, complete this simple user checklist before
calling your local HOOVER service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the water tank or bin filled? Please refer to 'Cleaner Maintenance'.
• Is the Filter blocked? Please refer to 'Cleaning the filter'.
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system'.
IMPORTANT INFORMATION
HOOVER spares and Consumables
Always replace parts with genuine HOOVER spares. These are available from your local
HOOVER dealer or direct from Hoover. When ordering parts always quote your model number.
Quality
HOOVER's factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001.

Your Guarantee

The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
subject to change without notice.
3 *Certain Models Only
GB
**May vary according to the model