Télécharger Imprimer la page

Philips Sonicare DiamondClean Serie Mode D'emploi page 9

Masquer les pouces Voir aussi pour Sonicare DiamondClean Serie:

Publicité

Les langues disponibles

Les langues disponibles

-
If this occurs remove any foreign objects from the charging pad
and/or try removing and replacing the handle on the charging pad.
Note: It takes approximately 12 hours to ensure battery is fully
charged. Charging times may vary if alternative wall adapters are
used.
This charger is designed to properly charge only one handle at a
time. Only the handle provided in this box should be used with this
charging system.
This charger is not compatible with other models of Philips
Sonicare.
Do not place metallic objects on the charging pad as handle charging
may be affected and may cause the metallic object to overheat.
Battery status (when handle is not on charger)
When removing the Philips Sonicare from the charging pad or after a
brushing session, a battery light at the bottom of the toothbrush will
indicate the status of the battery life.
-
Solid green LED: Between 2-3 weeks of brushing sessions left
-
Flashing green LED: Approximately 1 week of brushing sessions left
Only after a brushing is complete
-
Flashing orange LED and three beeps: Only a few brushing
sessions left
-
Flashing orange LED and two sets of five beeps: No brushing
sessions left (charge toothbrush)
Note: These indications are based off of using the device twice
per day in Clean Mode. Other modes or more frequent usage may
decrease the battery life.
Using the appliance
Brushing instructions
1
Wet the bristles (Fig. 8).
2 Apply a small amount of toothpaste on the bristles (Fig. 9).
35_021_1528_1_Booklet_A6_v1.indd 9
9
English
12/07/16 10:41

Publicité

loading