koban KDP1 Mode D'emploi page 80

All manuals and user guides at all-guides.com
KDP1 360 FP
Presence detector
Problem Possible cause
LED does 1.Time knob is not set to
not turn on "Test".
2.No power supply.
3.Wired incorrectly.
Nuisance There are heat sources,
triggering highly reflective objects or
any objects which may be
swayed in the wind within
the detection coverage.
Instructions manual | 80
Suggested solution
1.Set Time knob to "Test",
LED acts as an indicator only
in warming up time and test
mode.
2.Switch on the power.
3.Refer to wiring diagrams
(FIG.5-FIG.7).
Avoid aiming the detector
toward any heat sources,
such as air conditioners,
electric fans, heaters or any
highly reflective surfaces.
Make sure there are no
swaying objects within the
detection coverage.
www.grupotemper.com