Kaiterra Sensedge Mini Mode D'emploi page 4

Sensor Modules
The Sensedge Mini utilizes a modular design to allow for easy control and replacement of sensors. A
CO sensor and a temperature and relative humidity sensor are built into the core of the device, and
2
a variety of other sensors may be inserted using the two sensor bays on the lower side of the device.
To insert a sensor module, simply align it with the bay and press it in, ensuring the Kaiterra logo on
the plastic tab is facing outwards. When inserted correctly, the module will click into place, and an
LED light above the bay will briefly flash red if the device is powered on.
To remove a sensor module, gently pull the tab outward and remove the module from the bay. Make
sure to pull at a 90 degree angle.
Sensors may be inserted in either sensor bay, and in any order. They may be swapped both when the
Sensedge Mini is powered on and operational, and when the device is turned off.
By default, the Sensedge Mini is shipped with the KM-200 and KM-203 sensor modules, which
together measure PM and TVOC.
2.5
Sensor Module Status Light Indications:
Steady OFF Sensor working normal
Flash red once Sensor module powered on
Steady ON Sensor module needs to be changed
Flash Sensor module failure
Flash slowly Sensor module in sleep mode
Control and Status
Move the ON/OFF switch to turn on the device. The STATUS light will go on briefly to indicate the
device has been powered on.
To reset the device, use a paperclip and hold down the RESET pinhole. The STATUS light will flash red
rapidly, indicating that the reset is successful.
STATUS Light Indications:
Standard operation:
Steady OFF
Flash red once
Flash red rapidly
Configuration:
Flash yellow
Flash green rapidly
Glow green gradually
3
Device working normal
Device powered on
Reset successful
Device in configuration mode
Connecting to the network
Connecting to the cloud
Troubleshooting:
Steady ON in red Device failure
Flash red No network connection
Installation
The Sensedge Mini can be mounted on a concrete block wall, drywall, ceiling, or to an electrical box.
For detailed instructions on installation, power, and connectivity setup, please visit our support
center website at http://support.kaiterra.com/sensedge-mini or scan the QR code below.
Warranty Information
Kaiterra provides a 1-year limited manufacturer warranty on the Sensedge Mini. To obtain a copy of
the warranty for this product, please visit https://support.kaiterra.com/policies
Troubleshooting
For additional support, please contact your sales representative or email us at
support@kaiterra.com
4