Philips 42PF9945/12 Mode D'emploi page 20

Headphone
Multi channel Surround receiver
AUDIO
OUT
L
R
1
To select connected equipment
Press the v key on the remote control repeatedly, or select Source in the Setup menu (see p. 9) to
select , ,
EXT1 EXT2 EXT3
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
18
Insert the plug into the headphone socket L as shown.
&
Press ¬ on the remote control to switch off the internal
é
loudspeakers of the TV.
R
VGA
L
CENTRE
IN
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
&
Connect the audio cable to the multi channel Surround receiver
and to
AUDIO OUT L
é If you want the loudspeakers of your TV to act as centre
speaker, also connect an audiocable to the multi channel
R
Surround receiver and to the
VGA
L
CENTRE IN
your TV 2.
"
Select
Centre Input On
2
The loudspeakers of the TV will now only produce centre
sound, the loudspeakers connected to the audio receiver will
produce Surround Sound.The volume has to be controlled via
the multi channel Surround receiver.
Note: No sound will be heard when a TV channel or external source is
blocked via the Child lock menu (see p. 12).
, or according to where you connected your equipment.
YPbPr VGA
Headphone volume to adjust the
at the bottom of your TV 1.
and
R
at the bottom of
CENTRE IN
in the Source menu. See p. 9.