Publicité
RECESS MOUNTING
3. Place cabinets in rough opening and make sure they are installed square, plumb, and level.
4. Install a #10 X 2" screw [SS674] through top mounting hole in cabinet side and screw into wall stud as shown. Do not over-tighten
screws or cabinet box may deform.
NOTE: The #10 x 2" screw [SS674] is included in the hardware bag that came with the cabinet.
5. Once cabinets are installed square, plumb, and level, install #10 X 2" screws into wall studs through the seven remaining mounting
holes. Do not over tighten screws.
6. Drill one additional mounting hole at the top of the center cabinet (nearer to the hinge side of the cabinet) and install a #10 x 2" screw
[SS674] into the wall header.
3
5
© 2021 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
[SS674]
#10 x 2" Screw
6
4
6
PL Portray Full Length Cabinet Ganging Recess Mount Kit
[SS674]
#10 x 2" Screw
[SS674]
#10 x 2" Screw
Part no. CB-209-1372 3/29/21
Publicité
