Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing hitch
①
②
①
②
Figure 1
Conical Washer
Teeth side
Against hitch
1.
Remove frame plugs - Using a flat head screwdriver, remove (2) plastic plugs from the passenger side frame rail, repeat for opposite side.
2.
Install hitch - Raise hitch into position. Using the supplied hardware, apply blue thread locker to bolts then loosely install (4) M12 bolts and conical toothed washers as
shown. See Figure 1. NOTE: It may be necessary to clean debris from existing weldnuts in frame using a wire brush.
3.
Torque fasteners - Tighten all M12 CL10.9 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which
has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety
specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2023 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76635, 84635, CQT76635
FRAME RAIL
Fasteners
typical
both sides
①
Qty. (4)
②
Qty. (4)
Sheet 3 of 12
76635NP
Fastener Kit: 76635F
Bolt M12 X 1.25 X 40 CL10.9
Conical Washer 1/2"
3-1-23
Rev. A
Publicité
