Télécharger Imprimer la page

ECOVACS WINBOT 7 Serie Mode D'emploi page 5

Masquer les pouces Voir aussi pour WINBOT 7 Serie:

Publicité

Les langues disponibles

Les langues disponibles

Warning
If WINBOT is used to clean a window above ground level, the Safety Pod MUST be used.
WINBOT must be used in strict accordance with the directions in the Instruction Manual. ECOVACS can not be held
liable or responsible for any damages or injuries caused due to improper use.
1. Make sure that there is enough power cord for the WINBOT to clean the entire window without restricting its movement.
If there is not enough cord, it is not safe to use the WINBOT on that particular window until a WINBOT Extension Cord is
attached.
2. Loop one end of the Safety Rope around the Safety Pod's channel and pull it tight.
3. Loop the other end of the Safety Rope to the power connector on the power cord and tighten.
4. If an Extension Cord is attached, the Safety Rope must be tied to the power connector on the Extension Cord.
Note: Do NOT attach the Safety Rope to the thin part of the cord.
5. Press the Safety Pod suction cup FIRMLY in the lower corner on the opposite side of the glass you are cleaning. Make
sure the Safety Pod suction cup is securely in place.
6. Place WINBOT on the window, close the window if cleaning the outside of the window, and start WINBOT.
7. After WINBOT is done cleaning remove it from the window. Grasp the handle, switch the unit OFF, insert finger into Air
Release Trigger and pull up on it for 20 seconds until suction has diminished.
1. When using the product, a person should be in the vicinity to assist should there be a problem.
2. Before using the product on the outside of the window, you must use the Safety Pod. Read the
instructions on Safety Pod use in your Instruction Manual.
3. When removing the WINBOT, grasp the handle of the unit and move the switch under the handle to
Warning
the left - OFF position, and while still grasping the unit, insert finger into the Air Release trigger and
Pulling up on it, remove the unit from the window when the suction has diminished.
4. Please make sure the WINBOT's back-up battery is fully charged before use. If you have not used
the product for over a month or the product alarms (which consumes the back-up battery's power)
over an hour, please recharge its battery.
Live Smart. Enjoy Life.
EN
4

Publicité

loading

Produits Connexes pour ECOVACS WINBOT 7 Serie

Ce manuel est également adapté pour:

Winbot w710Winbot w730