Master-Slave-Mode - Laserworld Proline Série Mode D'emploi

Manual: Laserworld Proline Series
Channel
10 - zoom
11
12 - dot effect
13 - drawing
Please note that not each pattern can be combined with each effect.
Integrated Effects: (No grating effects for PRO-400G and PRO-1000G)
These can be set through selecting the following DIP switches additionally. The func-
tions can be used in automatic or music mode.
1. Normal scanner mode – for beam shows and graphics projections - DIP switch 5
2. Burst Grating mode – the scanned pattern is multiplied and covers a wide range -
DIP Switch 6
3. 3D Effect mode – creates a 3D-looking effect of the scanned pattern - DIP Switch 8
4. Radial Pattern Effect mode – a pattern is displayed in the center, the effect shows a
multitude of this projection in circles around the center projection - DIP Switch 7
Usage in ILDA mode:
To use these effects in ILDA mode it is necessary to assign a DMX address. If they are not
required, the DIP switches 1 - 5 - 10 are to be switched on.
8.

Master-Slave-Mode:

To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors of
the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
page 10 / 34
Value
0 - 85
86 - 170
171 - 255
0 - 255
0 - 255
0 - 127
128 - 255
Function
positive automatic zoom with increasing speed
negative automatic zoom with increasing speed
positive / negative automatic zoom with incre-
asing speed
pattern size / zoom
automatic dot effect with increasing speed
automatic drawing mode 1 with increasing
speed
automatic drawing mode 2 with increasing
speed