Philips HR2094 Mode D'emploi page 11

Filter (type HR2094 only)
With this filter you can make delicious fresh fruit juices, cocktails or soy
milk (see also 'Recipes'). The filter prevents pips and skins from ending up in
your drink.
1
Never overload the filter. Do not put more than 135g of dried soy beans
or 150g of fruit in the filter at the same time.
Preparing the filter for use
2
1 Place the blender jar with the blade unit interface attached on the
motor unit (1) and turn the jar until you hear a 'click' (2).
The blender can be placed on the motor unit in two positions.
2 Put the filter in the blender jar.
Make sure that the grooves of the filter fit exactly onto the ribs inside the
blender jar.
3 Make sure the appliance is plugged in.
Using the filter
1 Put the lid on the blender jar.
Make sure you place the lid on the blender jar in such a way that the drink
can be poured out through the strainer in the lid.
2 Put the ingredients in the filter.
Cut fruits into smaller pieces and soak dried pulses, such as soy beans,
before putting them in the filter.
3 Pour water or another liquid (milk, juice, etc.) into the blender jar.
4 Insert the measuring cup into the hole in the lid.
5 Select a speed or push one of the buttons (see section 'Control
knob'.
Let the appliance run for approx. 60 seconds.
Note: When you are processing a large quantity, we advise you not to put all
the ingredients in the filter at the same time. Start processing a small quantity
and let the appliance run for a few seconds. Then switch off the appliance
and add another small quantity, but do not exceed the top of the sieve mesh.
Repeat this procedure until you have processed all the ingredients. Always keep
the lid on the blender jar during processing.
After using the filter
1 Switch off the appliance and remove the blender jar from the motor
unit.
2 Pour out the drink via the pouring lip of the blender jar. Make sure
the lid is placed on the blender jar in such a way that the drink can
be poured out through the strainer in the lid.
Do not remove the lid, the measuring cup and the filter.
, Make sure that you have assembled the lid in the right position so
that the drink is poured out through the filter in the lid.
For optimal results, put the jar with the remaining ingredients back onto the
appliance and let it run for a few more seconds.
3 Always clean the filter immediately after use.
All manuals and user guides at all-guides.com
EnglisH
11