Publicité
Les langues disponibles
Les langues disponibles
programme, use Cotton-90 programme. Before
starting the programme, put max. 100 g of powder
anti-limescale into the main wash detergent
compartment (compartment nr. II). If the anti-
limescale is in tablet form, put only one tablet into
compartment nr. II. Dry the inside of the bellow with
a clean piece of cloth after the programme has
come to an end.
Repeat Drum Cleaning process in every 2
C
months.
Use an anti-limescale suitable for the washing
C
machines.
After every washing make sure that no foreign
substance is left in the drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
Foreign metal substances will cause rust stains
C
in the drum. Clean the stains on the drum
surface by using cleaning agents for stainless
steel. Never use steel wool or wire wool.
Cleaning the body and control panel
Wipe the body of the machine with soapy water
or non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Use only a soft and damp cloth to clean the control
panel.
Never use sponge or scrub materials. These
A
will damage the painted and plastic surfaces.
Cleaning the water intake filters
There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of
each water intake hose where they are connected
to the tap. These filters prevent foreign substances
and dirt in the water to enter the washing machine.
Filters should be cleaned as they do get dirty.
Close the taps. Remove the nuts of the water intake
hoses to access the filters on the water intake
valves. Clean them with an appropriate brush. If the
filters are too dirty, take them out by means of pliers
and clean them. Take out the filters on the flat ends
of the water intake hoses together with the gaskets
and clean thoroughly under running water. Replace
the gaskets and filters carefully in their places and
tighten the hose nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
All manuals and user guides at all-guides.com
washing water. Thus, the water will be discharged
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g.,
when moving to another house) and in case of
freezing of the water, water may have to be drained
completely.
Foreign substances left in the pump filter may
A
damage your machine or may cause noise
problem.
In order to clean the dirty filter and discharge the
water:
Unplug the machine to cut off the supply power.
Temperature of the water inside the machine
A
may rise up to 90 ºC. To avoid burning risk, filter
must be cleaned after the water in the machine
cools down.
Open the filter cover by pulling it from both sides at
the top.
You can remove the filter cover by slightly
C
pushing downwards with a thin plastic tipped
tool, through the gap above the filter cover. Do
not use metal tipped tools to remove the cover.
Follow the steps below to discharge the water.
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill the
flowing water into the container you have placed
in front of the filter. Always keep a piece of cloth
handy to absorb any spilled water. When the water
inside the machine is finished, take out the filter
completely by turning it.
Clean any residues inside the filter as well as fibers,
if any, around the pump impeller region. Install the
filter.
Seat the tabs in the lower part into their places first,
and then press the upper part to close.
10 - EN
Publicité
