Samsung RL48RWCPN Mode D'emploi page 13

5. Disassemble the COVER
WIRE DOOR on the top of
the fridge door with a flat-
head screw driver by putting
it into the indicated position
(Δ).
6. Disjoin the COVER WIRE
HINGE R from the ASSY
HINGE UPP as shown. Take
out the electric wire from the
COVER WIRE HINGE R.
7. Switch the direction of the
electric wire as below. Take
out the COVER WIRE HINGE
L from the underneath the
CAP CABI and rejoin it with
the electric wire.
8. With 11mm wrench,
separate the HINGE SHAFT
and then flip the HINGE and
reattach the HINGE SHAFT.
9-1. After rejoining the
COVER WIRE HINGE L
and the ASSY HINGE UPP,
Switch the position of the
GROMMET HINGE and the
CAP SPACE DOOR.
9-2. When disassembling
CAP SPACE, do not Push
both side hooks but bottom
hook as shown.
10. Switch the position of
the STOPPER DOOR and
the GROMMET HINGE as
shown.
DA99-03458D-05.indb 13 DA99-03458D-05.indb 13
All manuals and user guides at all-guides.com
COVER WIRE DOOR COVER WIRE DOOR
COVER WIRE HINGE R COVER WIRE HINGE R
ASSY HINGE UPP ASSY HINGE UPP
SHAFT SHAFT
GROMMET HINGE GROMMET HINGE
STOPPER STOPPER
GROMMET GROMMET
• DISASSEMBLY OF THE FREEZER DOOR
11. Remove 2 bolts and
screw to disassemble the
ASSY HINGE MID.
12. Disassemble the Freezer
door by lifting it upward.
Be careful not to drop and
scratch the Freezer door.
13. Disassemble the COVER
LEG FRONT by removing
the 2 screws.
14. Disassemble the ASSY
HINGE LOW as shown and
put the AUTO GUIDE upside
down, switch the position of
the SHAFT.
When joining, tighten a screw not to make
unpredicted noise.
• REVERSING THE HANDLE BAR
[FRIDGE/FREEZER]
15. Detach the CAP
SCREW HANDLE with flat
screwdriver and disassemble
the HANDLE BARs.
16. Switch the position of
the CAP HOLE DOORs,
pulling out and pushing
them in.
COVER LEG FRONT COVER LEG FRONT
AUTO GUIDE AUTO GUIDE
ASSY HINGE ASSY HINGE
LOW LOW
operating _13
15. 5. 14. 15. 5. 14. 5:46 5:46