TIPTEL 140 Manuel D'utilisation page 77

a. Indicator will light up when the unit is in use (off-hook).
7. LED indicator b. Indicator will light up when the unit receives message waiting signals.
c. Indicator will flash when unit is brought into setting mode (off-hook).
8. Press min. 3 secs to set the ringer melody.
a. For PABX use, Recall, used to transfer calls
9. R
b. On public lines: initiate functions on the public telephone line
10. 0 – 9, *, # Dialing keys.
11. Speaker Used for hands-free calls, used for ringer as well
12. Wall mounting
Turn 180 degrees to hang up the handset when the unit is wall mounted.
hook
13. Hook switch Press to end a call, handset on/off-hook
When the unit is mounted on the wall, this is used to hang up the handset
14. Handset hook
without going on-hook and breaking the line.
Switch from SR/HV/PR1/PR2 (see chapter Message Waiting Indication)
SR: Using burst ringing signal to switch on MWI
15. Message Waiting
HV: Using line voltage above 70V to switch on MWI
Switch
PR1: Using line polarity to switch on/off MWI
PR2: same as PR1, but polarity inverted
Note:
The Message Waiting Switch is good for operating the phone behind a PABX.
Switch position has to be PR1 or PR 2 for operation on a public line.
Getting started
7
e
n
g