Makita XSC02 Manuel D'instruction page 8

Lighting the lamp
CAUTION:
Do not look in the lamp or see the source of light
•
directly.
015632
Only to turn on the lamp, pull the switch trigger without
pressing the lock-off lever. To turn on the lamp and run
the tool, press the lock-off lever and pull the switch
trigger with the lock-off lever being pressed. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out 10 -15 seconds after releasing the
trigger.
NOTE:
Use a cotton stick to wipe the dirt off the lens of
•
lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Do not use gasoline, thinner or the like to clean
•
the lens of lamp. Using such substances will
damage the lens.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing blade
CAUTION:
Be sure the blade is installed with teeth pointing
•
up at the front of the tool.
Use only the Makita wrench to install or remove
•
the blade.
2
015633
1. Lamp
1
1. Shaft lock
2. Hex wrench
1
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the hex wrench to loosen
the hex bolt counterclockwise. Then remove the hex
bolt, outer flange and blade.
4
3
2
1
015634
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
When changing blade, make sure to also clean the upper and
lower blade guards of accumulated metal chips as discussed
in the Maintenance section. Such efforts do not replace the
need to check lower guard operation before each use.
Hex wrench storage
015635
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing or removing hook
CAUTION:
Never hang the tool on a waist belt or like.
•
Dangerous accidental cut may result.
Never hook the tool at high location or on
•
potentially unstable surface.
015639
The hook can be installed on the motor side of the tool
as illustrated. To install the hook, insert it into a groove
on the tool housing, and secure it with the screw. To
remove the hook, loosen the screw and take it off.
8
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
5. Cup washer
5
1. Hex wrench
1
1. Hook
2. Screw
1
2