Install Remote Control Batteries; Battery Installation; Precautions Concerning Batteries; Basic Operation - Vieta Home VH-MS260BK Manuel Utilisateur

Connect Power
Caution:
- Risk of product damage! Ensure that the power
supply voltage corresponds to the voltage printed
on the back or the underside of the unit.
- Before connecting the AC power cord, ensure
you have completed all other connections.
Connect the AC power cord to the wall socket.

Install Remote Control Batteries

The provided Remote Control allows the unit to be
operated from a distance.
When operating the Remote Control, point it towards
the remote sensor on the front panel of the unit.
Even if the Remote Control is operated within

the effective range (6m), remote control operation
may be impossible if there are any obstacles
between the unit and the remote control.
If the Remote Control is operated near other

products which generate infrared rays, or if other
remote control devices using infrared rays are
used near the unit, it may operate incorrectly.
Conversely, the other products may operate
incorrectly.
Battery Installation
1
Remove the battery compartment cover.
2
Insert two "AAA"± (R03 or UM-4) dry batteries.
Make sure that the batteries are inserted with their
positive "" and negative "" poles positioned
correctly.
3
Close the cover.
Precautions concerning batteries
Be sure to insert the batteries with correct positive

"" and negative "" polarities.
Use batteries of the same type. Never use

different types of batteries together.
Either rechargeable or non-rechargeable batteries

can be used. Refer to the precautions on their
labels.
When the Remote Control is not to be used for a

long time (more than a month), remove the battery
from the Remote Control to prevent it from leaking.
If the batteries leak, wipe away the leakage inside

the battery compartment and replace the batteries
with new ones.
Do not use any batteries other than those specified.

Do not mix new batteries with old ones.
Do not heat or disassemble batteries. Never throw

them in fire or water.
Do not carry or store batteries with other metallic

objects. Doing so could cause batteries to short
circuit, leak or explode.
Never recharge a battery unless it is confirmed

that it is a rechargeable battery.

Basic Operation

Power
You can use all the functions on the panel of the unit
or the remote control after connecting to a power
supply (called Standby Mode).
Turning the System On
Press the button to turn the system on from
standby mode.
Note:
When turning the system on, the system will continue
in the mode it was in when it was previously turned off.
Turning the System Off
Press the button again to turn the system off and
go to standby mode.
Note:
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended period
of time.
Select the correct TV system
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TV in your country.
1 In DISC mode or USB mode, press the SETUP
button.
2 Select [VIDEO].
3 Select [TV System] and then press the
4 Select a setting and then press the OK button.
- [NTSC] - For TV with NTSC color system.
- [PAL] - For TV with PAL color system.
- [AUTO] - For TV that is compatible with both
NTSC and PAL (multi-system).
5 To exit the menu, press the SETUP button.
Change system menu language
1 Press the SETUP button.
2 Select [LANGUAGE] and then press the
3 Select a setting and then press the OK button.
4 To exit the menu, press the SETUP button .
Setting the Clock
The built-in clock shows the correct time on the
display.
1 In standby mode, press and hold the CLOCK
button to activate the clock setting mode, hour
indicator will blink.
2 Set the hour with the
3 Press the OK or CLOCK button to confirm, minute
indicator will blink.
button.

button.

button or button.
 
ENGLISH
23