D+H KA 66-TW Notice Originale page 6

Intended use
- Chain drive for electric opening and closing of
wide windows and flaps in the facade and
roof area
- By VdS is the maximum load for one chain
at pressure = 600 mm and at tension = 1000 mm
- Operating voltage 24 VDC
- Useable for smoke ventilation, D+H Euro-SHEV
according to DIN EN 12101-2 as well as daily
natural ventilation
- Only for inside mounting
Safety notes
Operating voltage 24 VDC!
Do not connect directly to the mains supply!
- Connection has to be carried out only by an
authorized electrical specialist
- Danger of violent pressure in handaccessible area
- Keep away People from the operating area of the
drive
- Keep away children from the control
- Observe pressure load diagram of the chain!
- Use only in dry rooms
- Only for inside mounting
Use rain detector with danger of rain
(e.g. at domelights or roof windows)
- This product may not be operated without the
covering stoppers, which are delivered with
bracket sets
- Just use unchanged original D+H parts
- Observe mounting instructions of bracket set!
Observe enclosed red safety slip!
Mounting informations
Mount the drives mechanical
stress-free.
With that, more even load
distribution is ensured on all the
drive chains.
6/20
KA 66-TW
Performance features
- M
BSY + for a precise synchronous run
- ndividually programmable (via software SW-BSY+) I
- SHEV-high speed function (fast-running
feature in OPEN-direction)
- A
- P
(only with standard version)
- L
Pressure load diagram
Observe maximum pressure load of the chain!
Maximum pressure load
automatically identical with maximum pressure force
of the drive!
Extent of supply
Drive unit with 2,5 m silicone cable. Dependent on
the type of window, different bracket sets are
available separately.
At vertical active pulling
application (e.g. for a skylight)
the forces must be rearranged
by software SW-BSY+
English
icroprocessor controlled synchro electronics
nti pitch function for the main closing edge
ower supply is possible from both sides
ocking relief after closing
400
300
200
100
0
Stroke / (mm)
If after mounting, the measure X
is as bigger as 23 mm, null
balance with software SW-BSY+
is neccesary.
Closure Ranges will shift in
relation to new zero point.
≥ 23 mm ? X
99.823.90 2.1/07/11
per chain is not