Publicité
Les langues disponibles
Les langues disponibles
Problem
Possible cause
The iron is plugged
There is a connection problem.
in, but the soleplate
is cold.
The iron does not
There is not enough water in the
produce any steam.
water tank.
The iron is not hot enough to
produce steam.
You did not move the iron.
The iron is not plugged in.
The iron does not
Although the Auto Steam Sensor
produce any steam
technology covers a large number
when moved.
of ironing movements, there may
still be some movements that do
not activate the sensor.
The iron continues to
Because of the Auto Steam Sensor
steam when it is not
Technology, steam may continue
moved.
to be produced for 1-4 seconds
to ensure good wrinkle removal at
the end of the ironing stroke. This is
normal.
The iron does not
You have used the Steam Boost
produce Steam Boost.
function too often within a very
short period.
The iron is not hot enough.
Water droplets drip
You have not closed the cap of the
onto the fabric during
filling opening properly.
ironing.
You have put a chemical in the
water tank.
The Smart light flashes
The Safety Auto-off mode is active.
slowly.
The iron has been switched to
standby mode(see chapter 'Safety
Auto-off ').
Dirty water and
Impurities or chemicals present in
impurities come out
the water have deposited in the
of the soleplate or the
steam vents or on the soleplate.
soleplate is dirty.
All manuals and user guides at all-guides.com
EnGlish
Solution
Check the mains cord, the plug and the
wall socket.
Fill the water tank (see chapter 'Using
the appliance', section 'Filling the water
tank').
Wait until the Smart light has stopped
flashing and lights up continuously.
This iron is equipped with a motion
sensor and starts producing steam as
soon as it is moved.
Plug in the iron to switch it on.
Press the steam trigger to start
steaming.
If you want to avoid this, place the iron
on its heel.
Continue ironing in horizontal position
and wait a while before you use the
Steam Boost function again.
Wait until the Smart light has stopped
flashing and lights up continuously.
Press the cap until you hear a click.
Rinse the water tank and do not put any
perfume or any chemical in the water
tank.
To reactivate the iron, press the steam
trigger. The iron starts heating up again.
Clean the soleplate with a damp cloth.
15
Publicité
