Publicité
Les langues disponibles
Les langues disponibles
EN
SPEAKERS
FRONT
FRONT
R
L
•FR
•FL
PF24F
PF24F
Speaker
Enter
•FR/FL
FRONT RIGHT/LEFT
IV. HOME-CINEMA SETUP 5.1
1. Position of the speakers FL/FR
Before continuing the operation, please configure your installation by following the
instructions on the previous pages
2. Position of the center speaker C (PF11C, PF14C)
The center speaker must be positioned near the screen for realistic reproduction of
dialogue. Ideally, it is placed under the TV set if the TV stand enables it.
If a standard projection screen is used, the center speaker should be placed at the bottom
of the screen for best results. If a microperforated screen is used, it can be positioned
behind the screen.
3. Position of the subwoofer SW (PFSUB8, PFSUB10, PFSUB12)
The subwoofer should be placed between the two front speakers, either on the left or right
of the center speaker, and away from the wall.
4. Position of Surround speaker SL/SR (PF7SR, PF14LCR)
The dipole surround speakers are placed independently on the side walls. They must be
positioned at a height of 60 cm above the point of listening. Please, respect the position of
PF7SR speakers, using the indications written at their back.
or
PF6B
PF8B
PF14F
Description
Speaker Front right (R) /Left (L)
24
•SL
PF34F
6. Connections on Home-Cinema amplifier and Home-cinema preamplifier
It is essential to connect the speakers using the correct polarity. Make sure to connect the
" + " terminal of the speaker (Red) to the " + " output terminal of the amplifier. Then, make
sure to connect the " - " terminal of the speaker (Black) to the " - " output terminal of the
amplifier. A wrong connection would cause a cribled stereo image and loss of bass. Use
high quality speaker cable. Elipson speakers are supplied configured for use in a single
wired mode or bi-wiring. Bi-amp is also possible (see page 31).
•FL
•SW
ALL THE CONNECTIONS MUST BE MADE WITH THE EQUIPMENT TURNED OFF.
25
•C
•FR
•SR
Publicité
