Mini-SIM board
For the GSM connection, fit the Mini-SIM into its housing
until it locks into position as shown in the figure.
For the device to work properly, connect the GSM
antenna, using the supplied cable, to the corresponding
connector.
Jumper
These are necessary to configure the output voltage of
the Micro Match connector.
⚠ Leave the jumpers set as shown in the figure.
LED legend
Turned off
Flashes intermittently every 3 seconds
Flashes intermittently every second
Flashes intermittently three times per second
Turned on
LED 1 only works if it is configured to GSM.
All manuals and user guides at all-guides.com
LED 1
green
STATUS
GSM
Turned off
Not found
Found
Connecting
Configuring
Connected/configured
product complies with the law.
This
DISMANTLING AND DISPOSALThe packaging materials (cardboard, plastic, and
so on) should be disposed of as solid household waste. The product components
(metals; electronic boards, batteries, etc.) must be separated from other waste for
recycling. Check your local laws to properly dispose of the materials.
DO NOT DISPOSE OF IN NATURE!
THE CONTENTS OF THIS MANUAL MAY CHANGE, AT ANY TIME, AND
WITHOUT NOTICE.
MEASUREMENTS, UNLESS OTHERWISE INDICATED, ARE IN MILLIMETRES.
LED 2
LED 3
LED 4
green
red
red
CLOUD INTERNET POWER