RealFlame 26100242 Manuel Du Propriétaire page 14

Lighting Instructions
8
!
WARNING
immediat
the fireplace.
!
WARNING
while lighting fire table.
Using the Igniter
1. Read and understand all operating instructions before lighting.
2. Burner control knob mus
3. Connect propane (LP) cylinder (see above pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use your other hand to
the lighting procedure. If pilot still will not light, refer to the Troubleshooting Section.
Note: For initial start or after any cylinder change, continue to push the Control Knob IN
for 2 minutes to purge air from gas lines before proceeding.
7.
seconds after ignition.
9.
wait 5 minutes until gas has cleared and repeat
lighting procedure. If main burner still will not light,
refer to the Troubleshooting Section.
control knob
Using a Long Match or Lighter
1. Prior to lighting, use a shovel to move the lava rocks for access to the pilot.
2. Wearing heat resistant gloves, position the burning long match or burning butane
3.
wait 5 minutes for gas to clear and repeat the lighting procedure. If pilot still will not
light, refer to the Troubleshooting Section.
4. Remove long match/long butane lighter.
5.
cleared and repeat lighting procedure. If main burner
still will not light, refer to the Troubleshooting Section.
6. After lighting, use a shovel and heat resistant gloves to carefully move the lava rocks back
into their proper position.
7. Adjus
14
All manuals and user guides at all-guides.com
lean over the fire table while lighting!
to the desired height with the control knob.
F" and let the gas
F" position.
!
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
ration,
PUSH
IN
WARNING
Control Knob