Campingaz CAMPING DUO R Mode D'emploi page 14

Rate : SQn : 218 g/h (3 kW) - injector n° 073940
Category : butane direct pressure
GB
Thank you for choosing the Campingaz® Camping Duo™ R / Camping Duo™ Plus R / Camping Duo™ Grill R.
A - IMPORTANT: ALWAYS BE CAREFUL WHEN USING
GAS !
The purpose of these instructions is to enable you to use your Campingaz® appliance correctly and in complete safety.
Please read them carefully to familiarise yourself with the equipment prior to attaching the gas cylinder.
Please observe these instructions. Failure to observe these instructions may result in the user and people in the
immediate vicinity being put at risk.
Keep these instructions in a safe place so that you can refer to them if needed.
This appliance must only be used with Campingaz
The Société Application Des Gaz accepts no responsibility where cylinders of any other make are used.
This equipment should only be used outside premises and kept away from inflammable materials.
Do not use equipment which leaks, functions incorrectly or is damaged. Return it to your retailer who will inform you
of your nearest after-sales service.
Never modify this equipment or use it for purposes for which it is not intended
B - STARTING UP
WHEN USING THE STOVE FOR THE FIRST TIME
- Remove the pan support (8) by releasing the two metal rods
from their housing by applying inwards pressure and pull
(Fig. 13a).
- Remove the protection and reinstall the pan support (8) by
blocking the two metal rods in their housing (Fig. 13b).
UNFOLDING THE LEGS (6) (Camping Duo™ Plus R /
Camping Duo™ Grill R)
- For each leg, remove the two metal rods from their housing
applying inwards pressure then position the legs vertically
(fig. 4a). Make sure that the legs are firmly fixed.
FITTING TO CAMPINGAZ
(Where the existing cylinder is empty, read paragraph D:
"Removing the cylinder")
To install or remove a cylinder, always work in a well-
ventilated area, preferably outside and never in the
presence of a flame, heat source or spark (lit cigarette,
electrical equipment, etc.) at a good distance from other
people and flammable material.
- Check that stove's leaktight seal is installed and in good
condition, as is the thread on the tap (Fig. 2). Do not use
the stove if the seal is missing or damaged: return it to your
retailer.
- Check that the gas supply is fully turned off by turning the
control knob (1) clockwise as far as the handle (fig. 3). Fully
tighten the wheel to ensure that the gas is completely
turned off.
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE
CYLINDERS 904 or 907
®
cylinders 904 or 907. Using other gas cylinders may be dangerous.
®
- Place the gas cylinder on a flat surface.
Camping Duo™ Plus R / Camping Duo™ Grill R :
- Place the two legs in the exterior position (outside their
housing) by pulling the two metal rods from their housing
applying inwards pressure (see Fig. 4a).
- Install the connector underneath the stove on the cylinder
valve and turn the stove to screw it onto the cylinder.
- Bring the legs together to return them to their housing (see
Fig. 5).
Camping Duo™ R :
- Install the connector underneath the stove on the cylinder
valve and turn the stove to screw it onto the cylinder (Fig.
6).
- Make sure that the two stabilisers (7) are resting on the
edges of the cylinder (Fig. 6).
- The equipment is ready for use.
In the event of leakage (smell of gas prior to turning the
tap on), take the equipment outside immediately, in a well-
ventilated area with no combustion source, where the leak
can be located and halted. If you wish to check that your
equipment is correctly sealed, do so outside. Never attempt
to locate leaks using a flame. Use gas leak solution.
14