Preparation
Before you Begin
Tools and Parts Needed
Parts Included
30" Appliances
Dimensions for 30" Wall-Mounted Units
3/4"
29
(755mm)
29
1/16"
(738mm)
"
22
(559mm)
•
Phillips head screwdriver
•
Measuring tape
•
Drill with bit (1/8")
•
Phillips head screws (6)
"
24
(610mm)
28
1/4"
(718mm)
13/16"
27
(706mm)
27
"
(686mm)
min. 4
max. 31
23
7/8"
(606mm)
28
1/2"
(724mm)
3/4"
(121mm)
3/8"
(797mm)
Single Oven 30"
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4"
space between the side of the oven
and the wall/door.
For oven support, install 2x4's
extending front to back flush with the
bottom and the side of the opening.
The supporting base must be well
secured to the floor/cabinet and level.
Note: The conduit box must be
installed either above or below the
unit. If the conduit box is installed
below the unit, a 2" diameter hole or
space is required between the back
wall and the right rear of the 2x4
supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 190 lbs (86 kg).
English 3