Uline IGLOO H-5598 Instructions D'installation page 2

Figure 2
Figure 3
Locking
Figure 4
Casters
Figure 5
Igloo
Logo
PAGE 2 OF 9
All manuals and user guides at all-guides.com
INSTALLATION CONTINUED
3. Slide the cap catch bin onto the mounting bracket.
4. Connect the lid by pushing the three pins into the
5. Flip the base upside down to install the rigid casters
Rigid
Casters
6. Ensure both rigid casters are installed on the same
7.
8. Repeat on the other side of the base with the
9. Place cooler onto the base ensuring the Igloo logo
(See Figure 2)
clips located on the cooler. (See Figure 3)
using the caster mounting hardware. (See Figure 4)
side of the base. (See Figure 4)
While the base is upside down, place the bolts
through the caster holes from the top. From the
bottom, secure the washer on the bolt followed by
the nut and tighten using a wrench and the Phillips
screwdriver. (See Figure 4)
locking casters.
on the base is on the same side as the cooler opens.
(See Figure 5)
0521 IH-5598