Beha-Amprobe AT-6010-EUR Guide Rapide page 9

Special Application:
Tracing Non-Metallic Pipes and Conduits
Set-up:
1
Test Leads
1. Insert an conductive fish tape or wire inside the
conduit.
2. Connect the green and red test leads to
the Transmitter.
3. Connect the red test lead to the fish tape or wire
inside the conduit.
4. Connect the green wire to a separate ground.
Set-up:
2
Transmitter
Transmitter
indicator showing
signal in
HIGH mode
1. Turn on the Transmitter.
2. HIGH signal mode is automatically activated
when the Transmitter is turned on.
Tracing mode:
Tracing Non-Metallic
Pipes and Conduits
1. Start tracing while moving
the Receiver along the pipe
or conduit. The Receiver
will pick up the signal
conducted by fish tape or
wire through the conduit.
©2019 Beha-Amprobe For detailed specifications and ordering go to beha-amprobe.com 6011881 A
®
Advanced Wire Tracer - Quick Guide
Set-up:
3
Receiver
AT-6010-RE
1. Turn on the Receiver.
Tracing mode is automatically activated.
7