Roadstar HRA-1750D+BT Manuel D'instructions page 7

 Station Name: When an RDS station is received, the name of that station will be
displayed.
Ensemble Name: This displays the name of the multiplex that contains the station

you are listening to. A multiplex is a collection of radio stations that are bundled and
transmitted on one frequency. There are national and local multiplexes. Local ones
contain stations that are specific to that area.
Note: DAB+ unlike normal radio, groups together several radio stations and transmits
them on one frequency.
 Clock: This displays the current time provided automatically by the broadcaster.
Date: This displays the current date provided automatically by the broadcaster.

 DLS (Dynamic Label Segment): Dynamic label segment is a scrolling message
that the broadcaster may include with their transmissions. The message usually
includes information, such as programme details etc.
 Signal Strength: This shows a number to indicate the signal strength which is be-
tween 0 and 100, for example 12, 70 or 100. The stronger the signal, the greater the
number.
 Programme Type: This describes the "style" or "genre" of the programme that is
being broadcast.
 Frequency: This shows the frequency of the current station.
Audio Bit Rate: The display will show the digital audio bit rate being received.

 Stereo/Mono: The display will show if the station being received is in mono or ste-
reo.
FM RADIO OPERATION
Caution: Before listening to the radio, please check that the DAB/FM Antenna is cor-
rectly connected and adjusted for length and direction.
Tuning in to a Station
1. Rotate the SOURCE knob on the unit or repeatedly press button on the remote
control to select TUNER source. The word "TUNER" will be displayed on the LCD.
2. Select a station using one of the following methods.
Auto Tuning
Long pressing the TUNING +/- buttons on the unit or  buttons on the remote control
for 2 seconds or more, the frequency changes down or up automatically until a station is
found.
All manuals and user guides at all-guides.com
English 7 8 English
Manual Tuning
Repeatedly press the TUNING +/- buttons on the unit or  buttons on the remote
control to change the frequency until you find the station you want.
Preset Tuning (Available only after the stations are preset)
Repeatedly press the PRESET +/- buttons on the unit or PRESET /  /  buttons

on the remote control to select the desired preset number. Its band and frequency
are displayed on the LCD.
You can also use the 0-9 buttons on the remote control to input a number directly

and tune to the band and frequency with this number. If the number is less than 9,
press 0~9 buttons. If the number is over 9, press 10+ button and press the one of
the 0~9 buttons.
PROGRAM RADIO STATIONS
You can program a maximum of 20 preset radio stations (FM).
Automatically
Press the SCAN button on the unit or long pressing the PROG button on the remote
control for 2 seconds or more to activate automatic program mode.
"AUTO" is displayed on the LCD.

All available stations are programmed.

 The first programmed radio station is broadcast automatically.
Manually
1. Tune to a radio station.
2. Press the PROG button on the remote control to activate program mode. The pre-
set number will blink.
3. Repeatedly press the PRESET +/- buttons on the unit or PRESET /  /  buttons
on the remote control to allocate a number to this radio station. If you select more
than 20, the preset number will be changed to "1" automatically.
4. Press the PROG button on the remote control again to store the station.
5. Repeat above steps 1 to 4 for each station you want to store in memory with a pre-
set number.
Note: If the system is unplugged or if a power failure occurs, the preset stations will not
be erased.