emerio FN-114499.5 Mode D'emploi page 5

FN-114499.5
PARTS DESCRIPTION
1. Fan head
2. Small screw
3. Knob for adjusting tilt of fan head
4. Screw for fixing tilt of fan head
5. Connecting bolt
6. Speed control switch
7. Oscillation knob
8. Standing shaft
9. Standing base
10. Washer
11. Base locking screw
ASSEMBLING INSTRUCTIONS
1. Screw off the washer (10) and base locking screw (11) from the standing shaft (8). Attach the standing shaft
onto the standing base (9). Place the washer and base locking screw (11). Rotate the base locking screw to
fix the standing shaft firmly.
2. Place the fan head (1) at the top of the standing shaft (8). Push the connecting bolt (5) through the opening
provided as shown in the following drawing (a).
3. Above the position of connecting bolt, the standing shaft has one dent on one side and one hole on the
other side. Use a screwdriver to fix the small screw (2) into the dent. See the drawing (b) for a reference.
4. Under the position of the small screw, tighten the knob for adjusting tilt of fan head (3) onto the tip end of
the connecting bolt. See drawing (c).
5. At the other side of the standing shaft, tighten the screw for fixing tilt of fan head (4) into the hole and this
screw is located above the cap end of the connecting bolt after assembly. Make sure the fan head is firmly
attached onto the standing shaft. See drawing (d).
- 4 -
EN