Uline DOWNTOWN Serie Instructions D'installation page 3

6. Place tops over frame. Align holes on tops with holes
on frame and attach using 16 M6 x 65 mm bolts.
(See Figure 6)
Figure 6
Allen Wrench
Panel Hardware Kit
Aluminum M4 x 16 mm
Bracket x 3 Screw x 6
1. Panels have interlocking brackets with a hook (A)
and slot (B). Position panels with the hooks (A) facing
the slots (B) on the connector post. (See Figure 7)
2. Lift panel and slide hooks (A) down into slots (B).
NOTE: Make sure both pair of interlocking
brackets are connected – at the top and
bottom of each panel.
3. Position the assembled corner wall where user
intends to use it. The workstation is difficult to move
once it's fully assembled.
PAGE 3 OF 21
DESK ASSEMBLY CONTINUED
M6 x 65 mm
Bolt
PANEL ASSEMBLY PARTS LIST
M4 x 20 mm
Clip A x 2
Screw x 4
PANEL ASSEMBLY
7. L-Desk is now fully assembled. Insert black or silver
grommets based on preference.
For larger configurations, repeat steps 1-6
to assemble each additional L-Desk. Then
proceed to step 1 of Panel Assembly.
Post Hardware Kit
Universal
Trim Cover x 1
Connector Post x 1
Grommet
Completed
Assembly
M4 x 20 mm
Clip B x 4
Screw x 8
Clip A
Clip B
Figure 7
0223 IH-9207