Status Led; Normal Operation - AKG WMS40 CU40 Mode D'emploi

2. Check that the charger is connected
to power.
3. Place the transmitter in the appro-
priate charging receptacle for 30 to
60 minutes.
This is long enough to charge the
battery to capacity.

4.2 Status LED

The status LED indicates the current
operating status of the charger.
Important!
If the LED starts glowing GREEN
CONSTANTLY immediately after in-
serting the transmitter, you inserted
the transmitter the wrong way.
Place the transmitter in the charger as
shown in figs. 2 through 4.

4.2.1 Normal Operation

If you inserted the transmitter correctly
the LED will flash green for approx. 1
second and then glow red constantly
for 3 minutes while the battery is tested
automatically.
Once the battery test is completed, the
status LED indicates the current charg-
ing mode:
1. The LED glows red constantly:
• The battery inside the transmitter
is being charged.
2. The LED glows green constantly:
• The battery has been charged fully
and charging has stopped.
- Remove the transmitter from the
charging receptacle.
• If the transmitter switches off after
a few minutes of operation, the
battery is totally discharged.
- Charge the battery. If normal charg-
ing does not start on the third
attempt, the battery is defective.
- Replace the battery.
4.2.2 Error Modes
1. The LED is dark although you have
inserted a transmitter into the
charging receptacle:
• The charger is not connected to
power.
- Connect the charger to power,
referring to section 3.1.
• There is no battery inside the
transmitter and the transmitter is
OFF.
- Insert a suitable battery (refer to
section 3.2 for recommended
types) into the transmitter.
2. The LED flashes red irregularly:
- Immediately remove the trans-
mitter from the charging recept-
acle and check whether the bat-
tery inside is a rechargeable or
non-rechargeable type.
• The battery is a non-rechargeable
type (dry battery).
- Immediately remove the battery
13