AKG WMS40 CU40 Mode D'emploi page 12

Fig. 2: SO 40
Important (SO 40 - fig. 2): To prevent
the charger from toppling and the
transmitter from falling out of the
charger, disconnect the SO 40 from
the microphone before inserting
the SO 40 into the charger.
As soon as you place the transmitter
(1) in the charging receptacle (2)
charging will start automatically. The
12
Fig. 3: MP 40
status LED (3) will illuminate green for
about one second and then change
to constant red.
The battery will be fully charged after
a maximum period of one hour. The
status LED (3) will change to green.
4. Remove the transmitter (1) from the
charging receptacle (2).
Should you forget to remove the
transmitter, do not panic: charging
Fig. 4: GB 40
will switch off automatically and you
can leave the transmitter in the
charging receptacle for as long as
you like without risking to overcharge
the battery.
4.1.1 Charging during Breaks
E.g., during the lunch break at a conference
or between the soundcheck and concert:
1. Switch the transmitter off.