Uline H-7646 Instructions D'assemblage page 3

PEDESTAL AND DRAWER INSTALLATION
NOTE: Pedestals have metal perforated
key-hole style slots on top. Pedestal that is
installed on left-hand side of shop desk frame
will need to have perforation on front right
side removed. For pedestal installed on right-
hand side of shop desk frame, the front left
perforation will need to be removed.
NOTE: If perforations have already been
removed, skip to step 3.
1. Place flathead screwdriver on larger end of
perforation and hold firmly in place. Using a
hammer, tap the handle end of screwdriver until
metal perforation breaks off. (See Figure 6)
Figure 6
2. Using protective gloves, reach inside the top drawer
or door of pedestal and bend perforation until
opposite side breaks away from pedestal top.
(See Figure 7)
Figure 7
PAGE 3 OF 12
ASSEMBLY CONTINUED
3. Insert two pedestals on top of front and back
supports. (See Figure 8)
4. Open top pedestal drawer and/or cabinet door
of both pedestals. Using 9/16" wrench, attach
pedestals to frame with pedestal bracket, two
3/8-16 x 3/4" hex bolts and two 3/8-16 flange nuts.
(See Figure 9)
Figure 8
Figure 9
0922 IH-7646