NuTone VSC4R Instructions D'installation page 7

4. Attach each of the twisted pair of wires to the corre-
sponding screw terminal on the back of the camera.
Tighten each screw securely.
5. Dress extra cable
and position camera
into rough-in.
6. Fully seat the camera into the rough-in. Open the upper and lower access doors. Attach the camera to the rough-in
using a #6 x 1 1/2" screw and flat washer (supplied) at both the top and bottom of the camera. Level the camera,
tighten screws and close upper and lower access doors.
Important: If camera is exposed to outside elements, caulk should be added to the top and sides of the cam-
era at the wall surface. Do not caulk bottom surface.
Operational Checkout
Refer to the instructions provided with NuTone models VSUC4RK, or VSM4RK.
Camera Volume Adjustment
The VSC4R door camera is provided with a volume level adjustment set screw. The adjustment
has been pre-set at the factory to provide the optimal volume level at the door camera. The vol-
ume level can be adjusted if your specific application requires the level to be either increased or
decreased. Insert a jeweler's screwdriver into the small hole that is shown in the camera illustra-
tion. Rotate the small set screw to adjust the volume level.
Important: Do not use excessive force to rotate the screw. Damage could occur to the camera,
and loss of audio may result. Use extreme caution when making the adjustment. Do not use a
screwdriver that is too big for the application.
Camera Lens Manual Adjustment
The VSC4R door camera is provided with a manual camera lens adjustment. The adjustment can
be used to fine tune the angle of the camera lens to compensate for installations that are not
directly in line to the viewing area. The adjustment is located on the back of the camera, as
shown in the camera illustration. Move the adjustment control upward to lower the camera lens.
Move the adjustment control downward to raise the camera lens. The control can also be moved
left or right to adjust the side angle. Adjust the camera lens position to provide the best viewing
area for your installation.
Volume Adjustment
Lens Adjustment
7
Mounting Screw
and flat washer
VSC4R
VSC4R