Everik EM-AMB Instructions page 3

Part 2 – Attaching the arms to the panel
Important! Use extra care during this part of the installation. If possible, avoid placing your panel facedown
as it may damage the viewing surface.
NOTE: Your mount comes with a selection of different screw diameters and lengths to accommodate a wide
variety of TV models. Not all of the hardware in the kit will be used. If you cannot find the appropriate screw
size in the kit provided, consult the manufacturer of your TV for more information.
1. Determine the correct length of the screw to use by examining the back of your TV:
A. If the back of your TV is flat and the mounting holes are flush with the surface, you will use the shorter
screws (D, F, or H) from the hardware kit.
B. If the back of your TV is curved, has a protrusion, or if the mounting holes are recessed, you will need to
use the longer screws (E, G, or I) and may also need to use the spacers (L).
2. Determine the correct diameter of the screw to use by carefully trying one of each size (M4, M6, or M8)
from the hardware kit. Do not force any of the screws, if you feel resistance stop immediately and try a
smaller diameter screw.
3. Attach the mount arms to the back of your TV using the screws identified in steps 1 and 2 (See Fig.5):
A. If you are using the M4 or M6 screws you will also need to use the M6 washers (J). If you are using the
M8 screws you will also need to use the M8 washers (K).
If you are using the longer screws on a TV with a curved or recessed back, you may also need to use the
B.
spacers (L). Use one spacer or two spacers stacked as needed. Only use a spacer if necessary.
Part 3 – Final installation and adjustment
1. With the help of another person, carefully lift your panel and hang it on the wall plate. Do not
release the TV until the mounting arms have securely hooked onto the wall.
2. Move the safety tab located on each arm into position so that it prevents the TV from being
lifted form the mount. Insert a safety stopper (M) into each tab to keep it in place. A padlock
(not included) can be used in place of one of the safety stoppers to help prevent theft.
Important! The safety tabs and stoppers must be used at all times to prevent the TV from being
accidentally knocked from the mount.
3. Cables can be routed through the hooks located on the mount to keep them organized and out of the way.
3
All manuals and user guides at all-guides.com
For TV's with
Flat Backs
Safety Tab
For TV's with curved or Fig. 5
recessed backs.
Fig. 6
Safety Tab
AMB.ME.072011.IM