Publicité
Les langues disponibles
Les langues disponibles
Installation
Part 1A - Mounting the wall plate to dry wall
1. Use a high quality stud finder to locate a stud where you wish to install your mount. Mark both edges of
the stud to help identify the exact center.
Note: You must use the center of the stud to avoid cracking or splitting the wood during installation.
2. Place the mount against the wall over the marked stud. Make sure it is level.
3. While holding the mount in place, mark four locations (two at the top and two at the bottom)
for securing the mount to the wall. (See Fig. 1)
4. Drill a 6 mm (1/4") pilot hole at each marked location.
5. With the help of another person, place the mount against the wall over the drilled holes,
making sure the arrow on the mount points up. Attach the mount to the wall using the lag
bolts (A) and lag bolt washers (B) provided (See Fig. 2)
Do not over-tighten these bolts and do not release the mount until all bolts are in place.
6.
Ensure that the mount remains level after all bolts are secure.
Part 1B - Mounting the wall plate to concrete
1. Place the mount against the wall in the desired location. Make sure it is level.
With the help of another person, mark four locations (two at the top and two at the bottom)
2.
for securing the mount to the wall (See Fig. 3).
Set the mount aside and drill a 10 mm (3/8") hole at each marked location. Remove any
3.
excess dust from the holes.
Insert a concrete anchor (C) into each hole so that it is flush with the concrete surface
4.
(See Fig. 4). A hammer can be used to lightly tap the anchors into place if necessary.
Note: If the concrete wall is covered by a layer of plaster or drywall, the concrete anchor must pass
completely through the layer to rest flush with the concrete surface.
5. Place the mount against the wall over the drilled holes, making sure the arrow on the mount is pointed up.
Attach the mount to the wall using the lag bolts (A) and lag bolt washers (B) provided (See Fig. 2)
Do not over-tighten these bolts and do not release the mount until all bolts are in place. Ensure the mount
6.
remains level after all bolts are secured.
2
All manuals and user guides at all-guides.com
Fig. 1
Fig. 3
Fig. 2
Fig. 4
AMB.ME.072011.IM
Publicité
