AudioSonic CD-1581 Mode D'emploi page 6

note:
• Incorrect use of the batteries may result in electrolyte leakage having a corrosive
effect in the compartment.
• Do not mix different types of batteries: do not use alkaline batteries with saline
batteries, for example.
• Do not mix old batteries with new ones. Use batteries of the same type
recommended by the manufacturer.
• If the unit is not to be used for an extended period of time, remove the batteries as
damage may occur due to battery leakage.
using the aC supply
• Make sure that the voltage indicated on the manufacturer's nameplate in the
battery compartment corresponds to the voltage supply in your home. If this is
not the case, DO NOT use this appliance. Seek qualified advice.
• Connect the electrical power cable to the unit, then plug it into the wall outlet.
The wall outlet must be located near the product and be easily accessible.
• To turn power to the apparatus off, unplug the power supply cable from the wall outlet.
• To protect the unit during thunderstorms, unplug the power supply cable from
the wall outlet.
general operation
general operation
• Select the source by setting the FUNCTION SELECTOR to CD, OFF or RADIO.
• Set the desired volume level using the VOLUME KNOB.
• To turn off the unit, set the FUNCTION SELECTOR to OFF.
radio
• To listen to the FM radio, extend the telescopic antenna and adjust it for optimum
reception. Reduce the length of the antenna if the signal is too strong (if you are
very near the transmitter, for example).
• As the unit is equipped with a built-in antenna, the telescopic antenna is not
needed to listen to AM stations.
• Move the entire unit to adjust the built-in antenna for optimum reception.
6
Instruction Manual
radio reception
• Set the FUNCTION SELECTOR on RADIO.
• Position the BAND SELECTOR on the desired band: AM, FM or FM ST.
• Turn the TUNING KNOB to search for the desired station.
note:
• The FM stereo indicator comes on if the BAND SELECTOR is set on FM ST. and you
have tuned the radio to an FM stereo station.
• When you have finished listening to the radio, position the FUNCTION SELECTOR
to OFF.
Stereo headphones jack
• Connect headphones with the volume set low and increase it if required.
Prolonged listening through some headphones at high volume settings can result
in hearing damage.
• Reduce the VOLUME to a low level before putting on the headphones. You can
then adjust the VOLUME progressively to a comfortable level.
CD
The CD player supports audio discs, CD-R, CD-RW. Do not attempt to read CD-ROM,
CDi, VCD's, DVDs or DATA CDs.
note:
Even if this portable radio-CD player is able to read CD-R and CD-RW discs, it is not
possible to offer a 100% guarantee that all CD-R / RW discs can be read; playback
depends on the quality and condition of the blank discs that you use, among other
things. A playback failure does not necessarily indicate that the unit is malfunctioning.
• Position the FUNCTION SELECTOR on CD.
• To open the CD door, raise it by pressing the corner marked OPEN / CLOSE.
• Insert a CD, CD-R, CD-RW , printed surface facing upwards and gently close the CD
player door.
• Start playback by pressing PLAY / PAUSE.
• Press PLAY / PAUSE to PAUSE and PLAY. To stop CD playback, press STOP.