Publicité
STEP 5 MOUNTING THE BRACKET
Mount the Doorbell on a Wooden Surface
If you're mounting the doorbell on a wooden surface, you don't need to pre-drill
pilot holes. Use the provided screws to secure the Mounting Bracket on the wall, The
Screw Hole Positioning Card indicates the position of the screw holes.
What is required: Screwdriver, Mounting Bracket, 15° Mounting Wedge (Optional),
Screw Pack
Mounting Bracket
Phillips-Head Screwdriver
(Attached to 15° Mounting
(not provided)
Wedge)
Wall
Mounting
Bracket
Without 15° Mounting Wedge
10 English
15° Mounting
Screw Packs (Spare screws
Wedge (Optional)
and anchors are included.)
Wall
Mounting
Mounting
Wedge
Bracket
With 15° Mounting Wedge
Mount the Doorbell on Surfaces Made Out of Hard
Materials
1. If you're mounting the doorbell on a surface made out of hard materials, like brick,
concrete, stucco, drill 2 holes through the Screw Hole Positioning Card with a
15/64"(6mm) drill bit.
2. Insert the provided anchors, and then use the provided long screws to secure the
Mounting Bracket on the wall.
What is required: Power Drill, 15/64"(6 mm) Drill Bit, Mounting Bracket, 15°
Mounting Wedge (Optional), Screw Pack
Power Drill
15/64"(6 mm) Drill Bit
(not provided)
Mounting Bracket
15° Mounting
Screw Packs (Spare screws
(Attached to 15° Mounting
Wedge (Optional)
and anchors are included.)
Wedge)
1
English 11
Publicité
