Publicité
3.5 Connect the Doorbell Wires to the Doorbell
Connect the wires to the terminals at the back of the doorbell, then tighten the
terminal screws. Wire can connect to any terminal.
What is required: Wires and Wire Nuts (Optional) / Video Doorbell / Philips-head
Screwdriver
Extension Wires and
Wire Nuts (Optional)
Note:
• To prevent short-circuit, make sure the wires are not touching each other after
connecting them to the terminals.
• If the wires are too short, use the extension wires and wire nuts provided to
make them longer. Use electrical wiring tape instead if there is no more space
on the wall for wire nuts.
22 English
Video Doorbell 2K (Wired)
Phillips-Head Screwdriver
Model: T8210
(User provides it.)
3.6 Mount the Doorbell on the Bracket
Align the doorbell on top and then snap it on the bottom.
3.7 Restore Power
Switch the master circuit breaker back to ON.
You're all set!
If you want to detach the doorbell or recharge it, please refer to the corresponding
sections.
ON
ON
English 23
Publicité
