Dell PowerVault MD3200 Mise En Route page 14

Technical Specifications
Drives
PowerVault MD3200
PowerVault MD3220
RAID Controller Modules
RAID controller modules
Back-Panel Connectors (Per RAID Controller Module)
SAS connectors
Serial connector
Management Ethernet
connector
12
Getting Started With Your System
All manuals and user guides at all-guides.com
Up to twelve 3.5-inch SAS hot-swappable
hard drives (3.0 Gbps and 6.0 Gbps)
Up to twenty four 2.5-inch SAS hot-swappable
hard drives (3.0 Gbps and 6.0 Gbps)
• One or two hot-swappable modules with
temperature sensors
• 2 GB of cache per controller
• Four SAS IN ports to connect hosts
• One SAS OUT port for expansion to an additional
PowerVault MD1200 series enclosure
NOTE:
SAS connectors are SFF-8088 compliant.
One 6-pin mini-DIN connector
NOTE:
For technical support use only.
One 100/1000 Base-T port Ethernet for out-of-band
management of the enclosure
NOTE:
The default management port IP addresses for
the primary and secondary RAID controller modules
are 192.168.128.101 and 192.168.128.102, respectively.
By default, the management ports are set to Dynamic
Host Configuration Protocol (DHCP). If the controller
is unable to get an IP address configuration from
a DHCP server within a specified time out period
(approximately 3 minutes), it defaults back to
static IP addressing. For more information,
see the Deployment Guide.