Beko VCC 6424 WI Mode D'emploi page 9

4 Cleaning and care
Switch off and unplug the appliance before
cleaning it.
WARNING: Never use gasoline,
A
solvent, abrasive cleaning agents,
metal objects or hard brushes to
clean the appliance.
4.1 Replacing the dust bag
When the dust bag is full, the dust bag fullness
indicator (16) will turn red.
1. Open the top lid by pressing the button for
opening the dust container (12).
2. Remove the dust bag from the dust container
by pulling it upwards.
3. Remove the dust bag from its guide by pulling
it from its tray.
4. Dispose the full dust bag.
5. Holding its tray, push the new dust bag into the
bag holder. Ensure that it is fully seated.
6. Place back the dust bag holder into its place in
the dust container.
7. Close the upper cap of the appliance.
A
WARNING: Do not force the top
lid to close it, otherwise the plastic
parts can be damaged.
WARNING: Dust bags provided
from locations other than the
authorized dealers and services are
not original. Such dust bags have a
A
lesser quality and they become torn
in a shorter period and render your
appliance non-operational. Faults
caused by using unauthentic dust
bags are not covered by the scope of
the warranty.
A
WARNING: Do not wash the dust
bag.
Vacuum Cleaner / User Manual
4.2 Cleaning the filters
After each 5 dust bag replacement (may vary
depending on the frequency and area of usage),
clean the filters.
A
WARNING: Do not use appliances
producing hot air such as hair dryer
or heater to dry the filters.
WARNING: Do not install the
filters without completely drying
A
them; otherwise, smell of moisture
may occur during use, water can leak
from the back of the appliance or the
filters may get damaged.
A
WARNING: Attach the filters into
their places after they have dried.
4.2.1 Motor protection filter
1. Open the top lid by pressing the button for
opening the dust container (12).
2. Pull out the filter tray.
3. Remove the foam filter from the grid inside.
4. After washing the motor protection filter under
running water, wring it out slightly and leave it
to dry (for 24 hours minimum).
4.2.2 HEPA filter
1. Open the HEPA filter cover which is on your
appliance and remove the HEPA filter by pulling
it from its handle.
2. Shake off the HEPA outlet filter to eliminate the
dust on it. After that, you can wash it by holding
its clean side under running cool water.
3. If you wash the HEPA filter, dry it at room
temperature (for 24 hours minimum). Do not
use it before ensuring that it is completely dry.
9 / EN