Saba LVIF1019A++44M Mode D'emploi page 55

Express
Reduce the program time (Express can be use
when choose All in one, Intensive, Normal, ECO,
Glass, 90min)
10� Function
indicator
Extra drying
To dry dishes more completely� (It can only be
used with All in one, Intensive, Normal, ECO,
Glass, 90min�)
Water Softener
The water softener must be set manually, using the water
GB
hardness dial�
The water softener is designed to remove minerals and salts from
the water, which would have a detrimental or adverse effect on
the operation of the appliance�
The more minerals there are, the harder your water is�
The softener should be adjusted according to the hardness of the
water in your area� Your local Water Authority can advise you on
the hardness of the water in your area�
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the
amount of salt consumed based on the hardness of the water
used� This is intended to optimise and customise the level of salt
consumption�
Please follow the steps below for adjustment in salt
consumption�
1� Switch on the appliance;
106
2� Press the Start/Pause button for more than 5 seconds to start the
water softener set model within 60 seconds after the appliance
was switched on;
3� Press the Start/Pause button to select the proper set according
to your local environment, the sets will change in the following
sequence: H1->H2->H3->H4->H5->H6;
4� Press the Power button to end the set up model�
WATER HARDNESS
German French British Mmol/l
°dH °fH °Clarke
0 - 5 0 - 9 0 - 6 0 - 0�94 H1-> Light
6 - 11 10 - 20 7 - 14 1�0 - 2�0 H2-> 90
12 - 17 21 - 30 15 - 21 2�1 - 3�0 H3-> 90
18 - 22 31 - 40 22 - 28 3�1 - 4�0 H4-> ECO
23 - 34 41 - 60 29 - 42 4�1 - 6�0 H5-> ECO,
35 - 55 61 - 98 43 - 69 6�1 - 9�8 H6-> ECO,
Water Salt
softener consumption
level (gram/cycle)
0
GB
bright
9
mins Light
bright
12
mins, Rapid
Light bright
20
Light bright
30
Rapid Light
bright
60
90 mins
Light bright
107