AVG ARBM188SE2 Guide D'installation Et D'utilisation page 32

During the initial start-up, the display screen (including the main light) lights up completely during 3 seconds.
Then you can operate the unit and press the buttons.
Then press the middle button to start the unit Note: The refrigerator and freezer will display average
temperatures at the time of the initial start-up. In the event of a failure, the control will display an error
code. For more details, refer to the error codes section below.
Error codes
LED1\LED2 Flashing at the same time
LED1\LED3 Flashing at the same time
LED1\LED5 Flashing at the same time
LED2\LED4 Flashing at the same time
LED1 与 LED4 Flashing at the same time
SETUP INSTRUCTIONS
1-SETTING THE REFRIGERATOR TEMPERATURE
To set the refrigerator temperature simply press the B (Fridge) control button successively until you reach the
desired temperature (see below)
A
2-SETTING THE FREEZER TEMPERATURE
Repeat the same procedure for the freezer by pressing the C (Freezer) control button until you reach the desired
temperature (see below.)
Description of the Problem
Temperature sensor failure in refrigerating section
Sensor failure in freezing section
Defrost sensor failure in freezing section
Communication failure
Ambient temperature sensor failure
B
32
C