Kenwood Blend-X BLP90 Instructions page 8

All manuals and user guides at all-guides.com
troubleshooting guide
Problem Cause
The Blender will not No Power/Power On
operate. Light not illuminated.
Light not illuminated. Interlock not activated.
Goblet not fitted.
Blender not operating Goblet fitted and
but Power On ON/OFF lever in ON
indicator light on. position but speed
or programme not
selected.
Power On indicator Goblet refitted whilst
light flashing. variable speed selected.
Motor stops during Overload protection
operation. operated.
Operate for too long.
Poor blending result. Mix too dry and
clogging.
Insufficient processing
time.
Mix overprocessed.
Ingredients warm in Blender operated for
goblet. longer than 60 seconds
causing the temperature
of the ingredients to
increase.
Insufficient liquid added
or over processed.
If none of the above solve the problem see "Service & Customer Care".
Solution
Check blender plugged in.
Check goblet is located to
power unit correctly.
Either select a speed
manually or press a
programme button.
Turn the speed control
to the 'O' position and
reselect a speed.
Switch off, unplug and
remove excess ingredients
from the blender.
Allow the blender to rest
for a few minutes. Then
press the reset button
located on the underside
of the power unit.
Do not operate
continuously for longer
than 3 minutes.
Add more liquid.
Use the stir stick.
Increase the speed or
operating time.
Stop the blender when the
required consistency is
achieved.
Do not overprocess and
stop the blender when the
required consistency is
achieved.
Do not exceed the
recommended operating
time and use the correct
speed.
8
n